This kit is designed to easily take the 3rd Gen Tacoma to the next level. It provides the option to leave the stock catalytic converters in place to eliminate exhaust smell, be EPA compliant and have a quiet operation. (well…the turbo spool will be VERY apparent, along with the Blow Off Valve) See videos.

With stock exhaust and stock cats this kit made a very respectable 306whp/325wtq on just 7psi. Will easily make 400+whp when turning up the boost.

This kit could be installed in as little as 5 hours in a home garage. The biggest 3 steps are to simply drop the factory muffler exhaust section and replace it with the turbo. Remove factory airbox and replace it with intercooler piping. Install intercooler and mount up piping.

The turbocharger that was selected is an air cooled, triplex ceramic ball bearing with billet wheel Comp 5860. Meaning no oil feed lines, return lines, scavenge pump, wiring kits, oil pan spacers or pickup, or coolant lines are required for this kit. You simply just replace the factory muffler for a turbo and run some piping to the intercooler. And the best part...$5199 for a tuner kit!!! Tuning will be accomplished through VFtuning and your tuner of choice at an additional cost.

1. Comp oiless 5860 triplex ceramic ball bearing turbo with billet wheel. No lines to run, no pump, no electrical, no oil pan spacer or pickup needed. Just bolt it on and your done.

2. Vibrant Engineering Intercooler - Same company that makes our 1000HP intercoolers on other setups.

3. 44mm VS racing wastegate

4. 50mm Precision turbo blow off valve

5. 3" turn down pipe or upgrade to 3” single turbo back exhaust with open dump exiting the rear bumper/stock location.

6. All stainless steel hot side and aluminum cold side piping.

7. K&N conical filter with 4” inlet

8. All necessary brackets, mounting hardware, clamps, etc.

9. Full set of Install Instructions